When I run the setup program, there is no board shown.
When you use a board with a serial 9 pin (RS232) connector, you should not forget to connect the external power supply on the computer side of the cable.
The electronics of the board may be damaged due to reversed polarity of the power, (only possible with serial connectors with external powersource.)
Be sure there is no other program running that is using the DGT board.
When you are sure the power is connected correctly and the driver is installed, but there still no reaction, please This e-mail address is being protected from spambots. You need JavaScript enabled to view it DGT for a solution.
| < Prev | Next > |
|---|
